Configuring Time Clock to URL Address

Excerpt From An Article

This article is an excerpt from a more complete article: Setting up your ZK Time Clock

A hardware time clock should be configured to point to a URL for connectivity purposes. The following article will review the setup on the hardware time clock needed to achieve this setup.

Accessing the Admin Menu
  1. When you first turn on your Time Clock, you will see a screen similar to below that will be used by your employees to clock in/out.

    TimeClock_-_Clock_In_-_00.png

  2. To access the admin menu, press M button on the keypad. You will see a lock icon and a "Please verify" message.

    TimeClock_-_Verify_-_01.png

  3. Press 1 on the keypad for your User ID and press M.

    TimeClock_-_User_-_00.png

  4. When prompted for the password, press 998899 and press M.

    TimeClock_-_Password_-_00.png

  5. You should see the Main Menu that looks similar to below.

    TimeClock_-_Main_Menu_-_00.png

  6. If you do not interact with the device within a pre-determined time, the Time Clock will exit the main menu and return to the initial Clock In screen shown in the first step.
    • You can also extend the Menu Screen Timeout by going to: Personalize > User Interface > Menu Screen Timeout(s) > Select the desired time in seconds.
  1. If you have not already access the Admin menu, please refer to the steps in "Accessing the Admin Menu" above first. Use the arrow keys to select COMM. and press M.

    00_-_COMM.png

  2. Use the arrow keys to go down towards Cloud Server Settings and press M.

    01_-_Cloud_Server.png

  3. Enable "URL Mode" if it is not enabled. This can be done by highlighting "URL Mode" and pressing M.
  4. Go down to Server Address and press M.

    02_-_Cloud_Server_Settings.png

  5. For Server Address, enter www.infinityhr.com
    • If you are a CBIZ Client, please refer to the steps and credentials provided by CBIZ to set up your Time Clock with CBIZ.

    03_-_Cloud_Server_Name.png

  6. Make sure the “Enable Proxy Server” field is set to “OFF”. This can be done by highlighting "Enable Proxy Server" and pressing M.
    Proxy_Server_-_00.png
  7. Press ESC to return to the previous menu as needed.

Next Article

The next article is Configure Daylight Savings on Time Clock

Was this article helpful?
0 out of 0 found this helpful